mypros+
Model reference

Whirlpool WED9400VE1

Dryer

8 documents21 error codes4 service modes

Available documentation

Tech Sheet

  • TECH SHEET12 pg
    Covers this model
  • TECH SHEET - Whirlpool Dryer WED9500TW312 pg
    Covers this model

Service Flash

  • Service Pointer - 8178790 (Door not Closing)6 pg
    Covers this model

Tech Tip

  • Instruction Sheet - W10128087- Rev A - Special Handling7 pg
    Covers this model
  • Instruction Sheet2 pg
    Covers this model
  • Instruction Sheet12 pg
    Covers this model

Installation Guide

  • Instrucciones de instalacion20 pg
    Covers this model
  • Installation Instructions16 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WED9400VE1.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (21)

CodeMeaning
F:01Primary control failure.F:02Stuck button or user interface mismatch (appears ONLY in Diagnostic Test Mode).F:20No voltage detected at the heater relay (appears ONLY in Diagnostic Test Mode).F:22Outlet thermistor is open.F:23Outlet thermistor has shorted.F:26Motor drive system failure.F:28Moisture sensor strip is open (appears ONLY in Diagnostic Test Mode).F:29Moisture sensor strip has shorted (appears ONLY in Diagnostic Test Mode).F:31Low voltage condition (less than 30V) detected (appears ONLY in Diagnostic Test…F:50No voltage detected at the water valve relay (appears ONLY in Diagnostic Test…F:70No communication between the machine control and the console electronics.F:71No communication between the machine control and the console electronics.F:72Console electronics failure.F:73Console electronics failure.F:74Console electronics failure.F:75Console electronics failure.F:76Console electronics failure.F:77Console electronics failure.F:78Console electronics failure.L2Low line voltage (less than 30V) detected at installation.PFPower failure occurred while the dryer was running.

Service modes (4)

  • Customer-Focused Drying Mode Adjustment1
  • Diagnostic Test Mode1
  • Line Voltage DisplayAfter entering the Diagnostic Test Mode, waiting for the 5 second delay, and cycling through any…
  • Manual Load Test1. Ensure dryer is in standby mode. 2. Select any one button (except Pause/Cancel and Controls…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass