Model reference

Whirlpool WED9500TC2

Dryer

10 documents25 error codes5 service modes

Available documentation

Tech Sheet

Tech Sheet - do not Discard12 pg
Covers this model
TECH SHEET - Whirlpool Dryer WED9500TW312 pg
Covers this model

Service Flash

Dry Time Display Appears to Jump or Stall4 pg
Covers this model
Service Pointer - 8178790 (Door not Closing)6 pg
Covers this model

Tech Tip

Instruction Sheet - W10128087- Rev A - Special Handling7 pg
Covers this model
Instruction Sheet2 pg
Covers this model
Instruction Sheet12 pg
Covers this model

Quick Reference

Quick Reference Manual2 pg
Covers this model

Installation Guide

Instrucciones de instalacion20 pg
Covers this model
Installation Instructions16 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool WED9500TC2.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Dryer

AF on my Whirlpool WED9500TC2

M+

Low inlet air flow detected at install.

From Tech Sheet W14869181, p.33:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (25)

CodeMeaning

AFLow inlet air flow detected at install.F:01Primary control failure.F:02Stuck button or user interface mismatch (appears ONLY in Diagnostic Test Mode).F:20No voltage detected at the heater relay (appears ONLY in Diagnostic Test Mode).F:22Outlet thermistor is open.F:23Outlet thermistor has shorted.F:24Inlet thermistor is open (appears ONLY in Diagnostic Test Mode).F:25Inlet thermistor is shorted (appears ONLY in Diagnostic Test Mode).F:26Motor drive system failure.F:28Moisture sensor strip is open (appears ONLY in Diagnostic Test Mode).F:29Moisture sensor strip has shorted (appears ONLY in Diagnostic Test Mode).F:30Restricted air flow condition exists (appears ONLY in Diagnostic Test Mode).F:31Low voltage condition (less than 30V) detected (appears ONLY in Diagnostic Test…F:50No voltage detected at the water valve relay (appears ONLY in Diagnostic Test…F:70No communication between the machine control and the console electronics.F:71No communication between the machine control and the console electronics.F:72Console electronics failure.F:73Console electronics failure.F:74Console electronics failure.F:75Console electronics failure.F:76Console electronics failure.F:77Console electronics failure.F:78Console electronics failure.L2Low line voltage (less than 30V) detected at installation.PFPower failure occurred while the dryer was running.

Service modes (5)

Customer-Focused Drying Mode Adjustment1
Customer-Focused Drying Mode Adjustment (CF1/CF2/CF3)["In Standby mode (dryer plugged in but not powered up), press and hold the Dryness Level button…
Diagnostic Test Mode1
Line Voltage DisplayAfter entering Diagnostic Test Mode, waiting for the 5 second delay, and cycling through any saved…
Manual Load Test1. Ensure dryer is in standby mode. 2. Select any one button (except Pause/Cancel and Controls…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass