mypros+
Model reference

Whirlpool WED9600SU0

Dryer

8 documents21 error codes7 service modes

Available documentation

Tech Sheet

  • Tech Sheet W1011063812 pg
    Covers this model

Service Flash

  • Dry Time Display Appears to Jump or Stall4 pg
    Covers this model
  • Service Pointer - 8178790 (Door not Closing)6 pg
    Covers this model

Tech Tip

  • Instruction Sheet - 8574875 - Rev A - Special Handling4 pg
    Covers this model
  • Instruction Sheet2 pg
    Covers this model
  • Instruction Sheet12 pg
    Covers this model

Other

  • Service Pointer 81787334 pg
    Covers this model

Quick Reference

  • Quick Reference Manual2 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WED9600SU0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (21)

CodeMeaning
F:01Primary control failure.F:02Stuck button or user interface mismatch (only appears in diagnostic test mode).F:22Outlet thermistor is open.F:23Outlet thermistor has shorted.F:24Inlet thermistor is open (only appears in diagnostic test mode).F:25Inlet thermistor is shorted (only appears in diagnostic test mode).F:26Motor drive system failure.F:28Moisture sensor strip is open (only appears in diagnostic test mode).F:29Moisture sensor strip has shorted (only appears in diagnostic test mode).F:30Restricted airflow condition exists (only appears in diagnostic test mode).F:70No communication between the machine control and the console electronics.F:71No communication between the machine control and the console electronics.F:72Console electronics failure (F:72 through F:78).F:73Console electronics failure (F:72 through F:78).F:74Console electronics failure (F:72 through F:78).F:75Console electronics failure (F:72 through F:78).F:76Console electronics failure (F:72 through F:78).F:77Console electronics failure (F:72 through F:78).F:78Console electronics failure (F:72 through F:78).L2Line voltage not seen on L2 (display flashes L2).PFPower failure occurred while the dryer was running.

Service modes (7)

  • Adjusting Customer-Focused Drying Modes (CF1/CF2/CF3)["Activate the diagnostic test mode and advance past saved fault codes.","Press and hold the…
  • Adjusting Customer-Focused Drying Modes (TEST #5a)1
  • Customer-Focused Drying Mode Adjustment["Activate the diagnostic test mode and advance past saved fault codes.","Press and hold the…
  • Displaying Inlet Air FlowAfter all saved fault codes have been displayed in diagnostic mode, press the Wrinkle Shield button…
  • Displaying Line VoltageAfter all saved fault codes have been displayed in diagnostic mode, press the Cycle Signal button
  • Manual Load Test1. Dryer must be in standby mode (plugged in with all indicators off, or with only the Done…
  • Service Diagnostic Test Mode1. Dryer must be in standby mode (plugged in with all indicators off, or with only the Done…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass