Model reference
Whirlpool YWED9500TW3
Dryer
1 document25 error codes5 service modes
Available documentation
Tech Sheet
- Whirlpool Dryer YWED9500TW3 Tech Sheet56 pg
MyPros+ Max
Diagnose your Whirlpool YWED9500TW3.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (25)
CodeMeaning
afLow inlet air flow condition detected at installation (Amana models only).f:01Primary control failure.f:02Stuck button or user interface mismatch (appears only in Diagnostic Test Mode).f:20Heater failuref:22Outlet thermistor is open.f:23Outlet thermistor has shorted.f:24Inlet thermistor is open (Amana models only, appears only in Diagnostic Test…f:25Inlet thermistor has shorted (Amana models only, appears only in Diagnostic…f:26Motor drive system failure.f:28Moisture sensor strip is open (appears only in Diagnostic Test Mode).f:29Moisture sensor strip has shorted (appears only in Diagnostic Test Mode).f:30Restricted air flow condition exists (Amana models only, appears only in…f:31L2 line voltage errorf:50Water valve failuref:70No communication between the machine control and the console electronics.f:71No communication between the machine control and the console electronics.f:72Console electronics failure (F:72 through F:78).f:73Console electronics failure (F:72 through F:78).f:74Console electronics failure (F:72 through F:78).f:75Console electronics failure (F:72 through F:78).f:76Console electronics failure (F:72 through F:78).f:77Console electronics failure (F:72 through F:78).f:78Console electronics failure (F:72 through F:78).l2Low line voltage (less than 30V) detected at installation.pfPower failure occurred while the dryer was running.Service modes (5)
- Customer-Focused Drying Mode Adjustment (CF1/CF2/CF3)["In standby mode (dryer plugged in but not powered up), press and hold the Dryness Level (Sensor…
- Diagnostic Test Mode["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the…
- Displaying Inlet Air Flow Diagnostic (Amana Electric Models Only)["Enter the Diagnostic Test Mode.","Wait for the 5 second delay and cycle through any saved fault…
- Displaying Line Voltage Diagnostic["Enter the Diagnostic Test Mode.","Wait for the 5 second delay and cycle through any saved fault…
- Manual Load Test["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Whirlpool dryer models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass