mypros+
Model reference

Whirlpool JJW2427LL01

Oven

9 documents23 error codes3 service modes

Available documentation

Service Manual

  • EnerGuide1 pg
    Covers this model
  • Tech Manual76 pg
    Covers this model

Tech Sheet

  • Tech Sheet W11382345 RevA2 pg
    Covers this model

Bulletin

  • Service Pointer - W11823297 - Rev A - Door & Console Gaps or Alignment11 pg
    Covers this model
  • Installation Pointer - W11660287 - Rev A - Wall Ovens - Tall Vent Shield6 pg
    Covers this model

Service Flash

  • Service Pointer - W11815938 - Rev A - Wall Oven F8E0 Error Code6 pg
    Covers this model
  • Technical Service Pointer - W11803872 Rev B - Built In Oven Loose UI Board11 pg
    Covers this model

Tech Tip

  • Instruction Sheet W1181863510 pg
    Covers this model

Quick Reference

  • Manual de referencia rápida1 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool JJW2427LL01.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (23)

CodeMeaning
F1E0Oven user interface failure.F1E1Internal oven appliance manager error.F2E0Keypad disconnected.F2E1Stuck/Shorted keypad.F3E0Main oven sensor open or shorted.F3E1Bottom oven sensor open or shorted.F3E3Meat probe connector jack or meat probe shorted.F5E0Door and latch switch do not agree (main/upper oven).F5E1Latch not operating (main/upper oven).F5E3Door and latch switch do not agree (lower oven).F5E4Latch not operating (lower oven).F6E0Oven user interface lost communication.F6E1Over temperature (main/upper oven).F6E3Over temperature (lower oven).F6E4User interface/Appliance manager state status mismatch.F6E6Oven appliance manager lost communication (main/upper oven).F6E9Oven appliance manager lost communication (lower oven).F8E0Low fan speed underspeed.F8E1Low fan speed overspeed.F8E2High fan speed underspeed.F8E3High fan speed overspeed.F9E0Product not wired correctly (neutral connection switched with L1 or L2).No DisplayControl is blank

Service modes (3)

  • DiagnosticsSingle Ovens
  • Diagnostics mode (Double Ovens)Press UPPER OVEN > LOWER OVEN > LOWER LIGHT, then repeat the same 3-key sequence 2 more times…
  • Diagnostics mode (Single Ovens)Press KITCHEN TIMER > TOOLS > SELF CLEAN, then repeat the same 3-key sequence 2 more times (total 3…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass