Model reference

Whirlpool RBD305PDQO

Oven

4 documents28 error codes6 service modes

Available documentation

Tech Sheet

Whirlpool Built-In Oven Model Number Breakdown1 pg
Covers this model
TECH SHEET - Whirlpool Oven RBD305PDB66 pg
Covers this model
Whirlpool Oven RBD305PDB4 Tech Sheet8 pg
Covers this model
TECH SHEET - Whirlpool Oven RBD305PDB96 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool RBD305PDQO.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Oven

E1 on my Whirlpool RBD305PDQO

M+

Electronic control assembly failure.

From Tech Sheet W18685484, p.16:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (28)

CodeMeaning

E1Electronic control assembly failure.E2Keypad not connected.E3Keypad not connected, key held down too long, or key is shorted.F0Default F code F0-E0Default F code F0-E3Wiring harness cavity size does not match previously stored value F1Electronic control malfunction (all E codes other than E3).F1-E0Electronic control malfunction.F1-E1Keypad keytail not connected.F1-E5CANCEL key drive line open.F1-E6Key held down too long, or key is shorted.F2-E0Temperature sensor opened.F2-E1Temperature sensor shorted.F2-E2Keypad not connected.F2-E3Key held down too long, or key is shorted.F3Temperature sensor opened.F3-E0Temperature sensor opened (open circuit).F3-E1Temperature sensor shorted.F4-E0Meat probe malfunction F5Self-clean latch will not lock F5-E0Door is open, but latch is locked (door switch indicates open door and latch…F5-E1Self-clean latch will not lock.F5-E5Self-clean temperature 288°C (550°F) not reached within 45 minutes.F5-E6Door is open, but latch is locked.F5-E7Self-clean latch will not unlock.F6Switch pulse return line not connected F7Common wire (+5VDC) to latch switch and door switch is shorted to chassis…F7-E1Common switch wire (+5VDC) to latch switch and door switch is shorted to…

Service modes (6)

Bake temperature offset adjustment1
Default F code display (no failure diagnostic)Press and hold CANCEL key for 5 seconds
Fahrenheit to Celsius conversionPress the BROIL pad for 5 seconds
Fault Code Display["Press and hold CANCEL key for 5 seconds.","If no pre-existing fault, F0-E0 will be displayed."]
Fault Code Display (No Pre-existing Fault)["Press and hold UPPER OFF key for 5 seconds
Programming the Cavity Size["Within 60 seconds of power up, press the following touchpads in order

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass