Model reference
Whirlpool RBS305PDB14
Oven
8 documents33 error codes11 service modes
Available documentation
Tech Sheet
- Tech Sheet - 83017576 pg
- Whirlpool Oven RBS305PDQ6 Tech Sheet4 pg
Service Manual
- Kitchenaid Whirlpool Built In Single Double Electric Wall Ovens D Models Service Manual146 pg
- Service Manual 4317164 bochniak146 pg
Installation Guide
- Instruction Sheet1 pg
- Installation Instructions5 pg
- Instruction Sheet1 pg
Other
- servicemanual 4317164.pdf146 pg
MyPros+ Max
Diagnose your Whirlpool RBS305PDB14.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (33)
CodeMeaning
F0Default F codeF1Default F-CodeF1 E0Communications failure or EEPROM checksum failure.F1 E2UL A/D Error(s).F1-E0All E CodesF2Keypad is not connected, keypad held too long, or keypad is shorted.F2 E0Shorted key detected.F2 E1Key tail error (membrane tail connection issue).F2-E0Key held down too long, or key is shorted.F2-E1Keypad keytail not connected.F2-E5CANCEL key drive line open.F2-E6CANCEL key drive line open (grouped with E5).F3Wiring harness cavity size does not match the previously stored value (cavity…F3 E0Oven temperature sensor unplugged or open circuit.F3 E1Oven temperature sensor shorted.F3 E2Bake range over temperature condition.F3 E3Clean range over temperature condition.F3-E0Temperature sensor opened (R=2875 ohms by spec).F3-E1Temperature sensor shorted (R=825 ohms by spec).F3-E2Oven temp too highF3-E3Oven temp too highF4Temperature sensor open.F5Temperature sensor shorted or oven temperature is too high (runaway)F5 E0Door and door switches do not agree (door position mismatch).F5 E1Door latch not operating.F5 E2Latch error during clean cycle.F5-E0Door is open but latch is locked (door switch indicates open door while latch…F5-E1Self-clean latch will not lock or will not unlock.F6Shorted meat probe or miswired temp probe.F7Oven door latch will not lock.Service modes (11)
- Bake Temperature Offset Adjustment1
- Fahrenheit to Celsius ConversionPress the BROIL key for 5 seconds
- Fahrenheit to Celsius display changePress the BROIL keypad for 5 seconds
- Oven temperature calibrationTouch and hold the BAKE keypad for 5 seconds. The display will indicate the present oven…
- Programming Cavity Size (Self-Clean models)1. Within 60 seconds of power up, press the following keys in sequence
- Programming Cavity Size (Standard-Clean models)1. Within 60 seconds of power up, press the following keys in sequence
- Retrieve last error codePress and hold CANCEL/OFF key for 5 seconds
- Sabbath mode - Double oven1
- Sabbath mode - Single oven1
- Temperature adjustment (calibration)Press and hold BAKE pad for 5 seconds. Current offset (if any) is shown in 3-digit display. CAL is…
- Verify Cavity Size ProgrammingPress and hold CANCEL key for 5 seconds, then press and hold START key for 5 seconds.
Full entry steps, exit procedures, and test sequences are available in Max.
Related Whirlpool oven models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass