Model reference

Whirlpool YKESS907SS03

Range

4 documents33 error codes3 service modes

Available documentation

Tech Sheet

Tech Sheet8 pg
Covers this model
Tech Sheet - W10220963 - Rev A (FR)12 pg
Covers this model
Tech Sheet W10220962 YKERS807SS00 Rev A KA Range8 pg
Covers this model

Installation Guide

Installation Instructions24 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool YKESS907SS03.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Range

F0 E0 on my Whirlpool YKESS907SS03

M+

No error detected - normal operation.

From Tech Sheet W14572189, p.41:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (33)

CodeMeaning

F0 E0No error detected F0E0No error(s) found.F1 E0Internal oven manager (control board) fault.F1 E1Internal oven user interface fault.F1E1Internal appliance manager failure.F2 E0Keypad disconnected from control.F2 E1Stuck key or shorted key on keypad.F2E0Keypad disconnected from user interface.F2E1Stuck key or shorted key on keypad.F3 E0Main oven temperature sensor open or short-circuited.F3 E1Lower oven temperature sensor open or short-circuited.F3 E2Warming drawer temperature sensor open or short-circuited.F3 E3Meat probe sensor short-circuited.F3E0Main oven sensor open or shorted.F3E1Lower oven sensor open or shorted.F3E2Warming drawer sensor open or shorted.F3E3Meat probe sensor shorted.F5 E0Mismatch between door switch and latch switch signals.F5 E1Door latch does not function.F5E0Door switch and latch switch do not agree.F5E1Door latch not operating.F6 E0Loss of communication between user interface and appliance manager.F6 E1Oven cooking at excessive temperature (overheat during bake).F6 E2Excessive temperature during self-clean cycle.F6 E3Excessive temperature in small oven or warming drawer.F6 E4User interface and appliance manager mismatch (incompatible boards).F6 E5No cavity size programmed in control.F6E0Lost communication between user interface and appliance manager.F6E1Cook range over temperature.F6E2Clean range over temperature.

View all 33 error codes

F6E3Mini oven/warm drawer over temperature.F6E4User interface and appliance manager mismatch.F6E5No cavity size command programmed.

Service modes (3)

cavity_size_selectionEnter diagnostic mode (OFF, OFF, START)
diagnosticPress OFF, OFF, START in sequence
Diagnostics Mode["Press the OFF key to place the range in an idle state.","Press the OFF and START keys in the…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass