mypros+
Model reference

Whirlpool MAT23MN

Washer

1 document22 error codes8 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W11686105 - Rev B24 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool MAT23MN.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (22)

CodeMeaning
F0E2Over suds condition detected; suds prevent the basket from spinning up to speed…F0E4High water temperature detected (40.5°C / 105°F or higher) during the rinse…F0E5Off balance load detected during operation.F1E1Main control fault detected.F1E2Motor control fault on the motor control section of the main control.F2E1Stuck button detected; the START button has been actuated for 10 consecutive…F2E3Mismatch of main control and user interface; the UI identification does not…F3E1Pressure sensor fault; the main control detects an out of range pressure signal.F3E2Inlet water temperature fault; the inlet thermistor is detected to be open or…F5E1Lid switch fault; lid is in locked state but lid switch is open, or the main…F5E2Lid lock fault; lid lock has not moved into locked position or motor cannot be…F5E3Lid unlock fault; lid lock has not moved into unlocked position or motor cannot…F5E4Lid not opened between cycles; user presses START after several consecutive…F7E1Basket speed sensor fault; the main control cannot determine speed of basket or…F7E5Shifter fault; the main control cannot determine the position of the shifter.F7E6Motor fault; indicates an open clockwise or counterclockwise circuit of the…F7E7Motor unable to reach target RPM; basket speed sensor detects that target RPM…F8E1Long fill; the water level does not change for a period of time or water is…F8E3Overflow condition; main control senses water level that exceeds the washer's…F8E5Hot and cold inlet hoses are reversed.F8E6No fill; the water level does not change for a period of time or water is…F9E1Long drain; the water level does not change after the drain pump has been on…

Service modes (8)

  • Calibration Mode["Ensure washer is in standby mode (plugged in, all indicators off).","Place cycle selector knob…
  • Drain & Spin Cycle["Ensure washer is in standby mode (plugged in, all indicators off).","Place cycle selector knob…
  • Fault Code Display Mode["Ensure washer is in standby mode (plugged in, all indicators off).","Place cycle selector knob…
  • Manual Overview Test Mode["Ensure washer is in standby mode (plugged in, all indicators off).","Place cycle selector knob…
  • Quick Overview Test Mode["Ensure washer is in standby mode (plugged in, all indicators off).","Place cycle selector knob…
  • Software Version Display Mode["Ensure washer is in standby mode (plugged in, all indicators off).","Place cycle selector knob…
  • Tachometer Verification Mode["Ensure washer is in standby mode (plugged in, all indicators off).","Place cycle selector knob…
  • UI (Rotary Switch) Test Mode["Ensure washer is in standby mode (plugged in, all indicators off).","Place cycle selector knob…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass