mypros+
Model reference

Whirlpool W11447418

Washer

1 document21 error codes9 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W11447418 - Rev A2 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool W11447418.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (21)

CodeMeaning
F0E2Oversuds condition detected.F0E4High water temperature during rinse cycle, spin limited by water temperature.F0E5Off balance load detected.F1E1Main control fault.F1E2Motor control fault.F2E1Stuck button detected on user interface.F2E3Switch mismatch detected.F3E1Pressure system fault.F3E2Inlet water temperature fault.F5E1Lid switch fault.F5E2Lid lock faultF5E3Lid unlock faultF5E4Lid not opened between cycles.F7E1Basket speed fault.F7E5Shifter fault.F7E6Motor fault.F7E7Motor unable to reach target RPM.F8E1Long fill or no fill condition.F8E3Overflow condition detected.F8E6Hot and cold water supply lines are reversed.F9E1Long drain condition.

Service modes (9)

  • AATCC Cycle["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until status LEDs indicate mode…
  • Dry Factory Diagnostics["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until status LEDs indicate mode…
  • Factory Cal Test Cycle["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until status LEDs indicate mode…
  • Factory Diagnostics Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until status LEDs indicate mode…
  • NVH Cycle["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until status LEDs indicate mode…
  • Service Diagnostic Test Modes["After power is applied, wait 10 seconds before activating.","RESET
  • SW Version Display Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until status LEDs indicate mode…
  • Tachometer Verification["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until status LEDs indicate mode…
  • UI Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until status LEDs indicate mode…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass