mypros+
Model reference

Whirlpool WFW5720RR0

Washer

7 documents26 error codes7 service modes

Available documentation

Service Manual

  • Dimension Guide15 pg
    Covers this model
  • Technical Manual - W11744594 - Rev D - Whirlpool 27" Front Load Washer90 pg
    Covers this model

Service Flash

  • Service Pointer - W11758510 - Rev D - Front Load Washers F8E1 No Water Detected, F5E3 Contact Service Error, Door Remains Locked, Random Error Codes8 pg
    Covers this model
  • Service Pointer - W11807384 - Rev A - Service Tool 2.0 Bluetooth Connection6 pg
    Covers this model

Bulletin

  • Service Pointer - W11819607 - Replacing both Appliance Control Unit (ACU) and Human Machine Interface (HMI) - Rev a17 pg
    Covers this model

Quick Reference

  • Quick Start Guide2 pg
    Covers this model

Other

  • W11678280 - Rev B3 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WFW5720RR0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (26)

CodeMeaning
F0E1Load detected during Clean Washer cycleF0E2OversudsF0E3OverloadF0E4Spin speed limited by water temperature.F0E5Off balance load detectedF1E1Appliance Control Unit (ACU) fault.F1E2Fault of the motor control section of the ACU.F4E2Main heater stuck onF4E3Main heater not turning onF5E1Door switch faultF5E2Door lock will not lock or door lock failureF5E3Door unlock failureF5E4Door not opened between cyclesF6E1Communication errorF6E2Communication errorF6E3No communication between ACU and DMS.F7E2Motor control internal faultF7E8Motor control over-temperature detected.F7E9Motor locked rotor.F7EAMotor control lost phase fault (also displayed as F7E10).F7ECMotor control motor overload fault (also displayed as F7E12).F8E1No fill, long fill, or water taps closedF8E3Overflow condition detected.F8E5Hot and cold water supply hoses are reversed.F9E1Long drainFAE1Shipping bolts are still installed.

Service modes (7)

  • Component Activation["Enter Service Diagnostic Mode.","Navigate to Service Diagnostic.","Select Component…
  • Diagnostics Cycle["Enter Service Diagnostic Mode.","Navigate to Service Diagnostic.","Select Diagnostics…
  • Factory Calibration Cycle["Enter Service Diagnostic Mode.","Navigate to Factory Diagnostics.","Select Factory Calibration…
  • Factory Reset["Enter Service Diagnostic Mode.","Navigate to Factory Diagnostics.","Select Factory Reset."]
  • HMI Test["Enter Service Diagnostic Mode.","Navigate to Service Diagnostic.","Select HMI Test.","Sub-tests…
  • Sensor Feedback["Enter Service Diagnostic Mode.","Navigate to Service Diagnostic.","Select Sensor Feedback."]
  • Service Diagnostic Mode["Ensure washer is in standby mode (plugged in with all indicators off).","Wait 30 seconds after…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass