ASKO Dryer Error Code F1

F1 on an Asko condenser dryer indicates an overfill condition in the condensation water system. The dryer has detected that the water collection tank is full, that the drain pump or hoses are blocked, or that the float switch has triggered unexpectedly. The machine stops automatically as a safety measure to prevent water from overflowing inside the appliance.

No, you should not continue running the dryer while F1 is active. The machine stops automatically for a reason: continuing to operate with a full or malfunctioning condensate system could cause water to overflow into internal components, potentially damaging the dryer or creating moisture-related hazards. Resolve the underlying cause before resuming normal use.

Repair costs vary depending on the root cause. If the fix is simply emptying the tank or cleaning hoses, there is no parts cost. Replacing a defective float switch or drain pump typically costs between $80 and $200 including parts and labor, depending on your location and the specific components required. Replacing a faulty control unit is the most expensive scenario, generally ranging from $200 to $450 or more.

In many cases, yes. Start by emptying the condensation water tank and restarting the machine, as a full tank is the most common cause. If the error returns, inspect the drain hoses for blockages and clean them. If the float appears stuck, carefully free it by removing any debris. Electrical testing of the pump and control unit typically requires a multimeter and some technical comfort, so those steps are better suited to experienced DIYers or a technician.

A reset may temporarily clear the display, but the F1 code will return if the underlying problem has not been addressed. You must empty the water tank, clear any hose blockages, and verify that the float and pump are functioning correctly. If the pump or control unit has failed, a reset alone will not resolve the fault.