ASKO Dryer Error Code F2

F2 on an Asko TD60.1 dryer means the appliance reached its maximum permitted programme time without completing the drying cycle. The control system uses this timeout as a safety and efficiency measure to stop the dryer from running indefinitely. It typically points to a maintenance issue such as a full water container, blocked lint filter, or clogged condenser rather than a component failure.

Resetting the dryer may clear the F2 display temporarily, but the error will return if the underlying cause is not addressed. You should empty the water container, clean the filters, and improve room ventilation before resetting and restarting the cycle. A reset alone without maintenance is not a lasting fix.

If the issue is just a clogged filter, blocked condenser, or full water container, there is no parts cost and you can resolve it yourself at no charge. If a technician visit is needed to clean a severely blocked condenser or inspect internal components, labour costs typically range from $80 to $180 depending on your location. Replacement parts such as a moisture sensor or heating element, if required, can add $50 to $200 or more to the total repair cost.

Start by emptying the condensed water container, cleaning the fluff filter, and inspecting the condenser for lint buildup. Make sure the room has adequate ventilation by opening a door or window to supply cooler air. After completing these steps, reset the dryer and run a short test cycle. If F2 returns repeatedly despite cleaning, the moisture sensor or heating element may need professional inspection.

The F2 code causes the dryer to stop the cycle, so the appliance is not actively running when the error is displayed. It is safe to perform the recommended maintenance steps and restart the machine. However, continuing to run the dryer repeatedly without addressing airflow and drainage issues could lead to overheating over time, so the root cause should be resolved before regular use continues.