Error code reference

ASKO Dryer Error Codes

34 error codes documented with diagnostic procedures.

Have your model number? Get codes specific to your unit.

Clean auto filterDisplayed according to the interval set in the service menu indicating that the water…Clean condenserDisplayed according to the interval set in the service menu indicating that the…Clean filterDisplayed according to the interval set in the service menu indicating the evaporator…Clean Lint FilterIndicated when air circulation and temperature are incorrect, possibly due to high…F1Overfilling-the condensation water tank is full, condensing waterpump or hoses blocked…F10Overflow fault F2Maximum permitted programme time reached (TD60.1, Panel type 1).F29Evaporator filter (net filter + foam filter) or evaporator is clogged on heat pump models.F3Thermistor fault F30Maximum program time exceeded F4Fluff detected in the fluff filter or in the condenser (indicated after end of program).F5Maximum permitted programme time exceeded-the machine stops after 3 hours F9Front thermistor fault-the front thermistor is defective or the control is not in contact…H1Humidity sensor error H2Drying temperature sensor open/short error H3Flame detector open defect (Gas Type)-occurs when flame detector is still open after 300…H4Both heaters disconnected (Electric Type)H5Heater overheated (Electric type only)H6One heater disconnected (Electric Type)-temperature difference is between 5°C and 19°C…H7Gas valve defect or gas blocked off (Gas type only)H8Igniter defect or flame detector short (Gas Type)-flame detector must open within 120…Heat protectionA thermostat in the rear section has indicated that heat has risen excessively…Max Program TimeThe cycle time exceeds 200 minutes; the cycle interrupts and the program is cleared Maximum program timeThe machine has been running for its maximum time (3 hours) and has stopped, possibly due…Over flowThe condensation tank is full; if condensation is pumped directly out via the drain hose…Over flow faultThe microswitch is opened when a full condensed water tank is detected; if the…OverfullThe condensation water tank is full (T780), or the bottom water container is full because…SensorDry clothes in drum at startup, humidity sensor not installed properly in fan housing or…Sensor errorFault in the humidity sensor Sensor faultFault in the moisture sensor; the moisture value is unreasonable (<0V or >6V for 300…ThermistorThe thermistor may have become disconnected or have an internal fault, causing potential…Thermistor errorThermistor fault detected Thermistor faultOpen or short circuit in the thermistor; the thermistor may have become disconnected or…Three hoursThe machine has run the maximum drying time of three hours, indicating a possible issue…

Get the full diagnostic procedure for any code

Step-by-step tests, expected values, wiring diagram references, and verified part numbers.

Get Started $9.95 3-day pass

$29/month for all brands and Max diagnostics, with 70 Max messages a day. Plus applicable tax.

More ASKO error codes