Electrolux Dishwasher Error Code Er

The Er code on an Electrolux dishwasher indicates a membrane switch failure. The control board has detected that a button on the touchpad keypad has been in a continuously closed, or pressed, state for one full minute. This signals that the membrane switch is malfunctioning and needs attention before the dishwasher can operate normally.

A power reset may temporarily clear the Er code, but it will return if the underlying membrane switch fault is still present. Because the error is triggered by a hardware condition in the keypad itself, resetting the control does not address the root cause. Replacement of the faulty console assembly is needed for a permanent fix.

The cost depends on whether you do the repair yourself or hire a technician. A replacement console assembly for an Electrolux dishwasher typically ranges from roughly 80 to 200 dollars for the part alone, depending on the specific model. If you use a professional technician, expect total costs including labor to fall somewhere in the range of 150 to 350 dollars.

The primary fix is replacing the console assembly, which includes the membrane switch and keypad as a single integrated unit. A knowledgeable DIYer comfortable with basic appliance disassembly can often complete this repair. However, if you are unsure about working with the control panel or wiring connections, hiring a qualified technician is the safer choice.

The Er code typically prevents normal operation to protect against unintended commands caused by the faulty membrane switch. Attempting to force the dishwasher to run in this state is not recommended, as the control panel cannot reliably interpret user input. The safest approach is to leave the unit powered down until the console assembly is replaced.