Electrolux Dishwasher Error Code hs

The hs code means the control board has detected a problem with the Hall effect sensor in the wash motor. This sensor monitors the motor's rotation speed and position. When the control cannot read a valid signal from the sensor, it stops the cycle and displays the hs fault to prevent potential motor damage.

It is not advisable to continue running the dishwasher while the hs code is active. The control halts the cycle specifically because it cannot confirm the wash motor is functioning correctly. Running the appliance in this condition could risk further damage to the motor or control board.

A reset may temporarily clear the hs code from the display, but the fault will return if the underlying problem with the Hall effect sensor or its wiring has not been resolved. Resetting can be useful to confirm whether the fault is intermittent or persistent, but it is not a repair. The sensor connections and motor should be inspected before relying on a reset as a solution.

A knowledgeable DIYer can start by checking the wash motor's wiring harness connector for loose connections, corrosion, or visible damage, which requires no special tools and no parts. If the wiring checks out and the fault persists, replacing the wash motor assembly is the likely next step, which involves disconnecting the appliance from power, accessing the motor beneath the tub, and handling electrical components. If you are not comfortable working with appliance wiring, a qualified technician is recommended.

Repair costs vary depending on the root cause. If the issue is simply a loose or corroded connector, the repair may cost little to nothing beyond a service call fee, typically in the range of $75 to $150. If a new wash motor assembly is needed, parts and labor combined can range from $200 to $450 or more depending on the specific model and local labor rates.