Electrolux Dishwasher Error Code LS

The LS code on an Electrolux dishwasher means the rinse aid dispenser is empty or low and needs to be refilled. It is a maintenance reminder, not a mechanical fault. Refilling the rinse aid through the dispenser cap on the inner door panel will typically clear the code automatically.

Yes, running the dishwasher with an LS code is safe and will not cause damage to the appliance. However, without rinse aid, you can expect noticeably worse drying performance and increased water spotting on dishes and glassware. It is best to refill the dispenser before the next cycle for optimal results.

In most cases, the only cost is a bottle of rinse aid, which typically runs between $4 and $12 at most grocery or hardware stores. If the dispenser assembly or float sensor has failed and requires replacement, parts can range from $15 to $60 depending on the specific component, plus any labor costs if a technician is needed.

Open the rinse aid dispenser cap located on the interior of the dishwasher door and fill the reservoir with rinse aid until it reaches the full indicator. Close the cap securely and run a wash cycle. The LS alert should clear on its own once the float sensor detects the correct level. If it does not clear, inspect the dispenser and float sensor for damage or debris.

A basic reset will not permanently clear the LS code because the underlying cause, a low or empty rinse aid reservoir, will still be detected by the float sensor. The code will return as long as the rinse aid level remains insufficient. You need to refill the dispenser to resolve the alert properly.