Electrolux Dishwasher Error Code PA

The PA code means the dishwasher's control system has detected that the door is not properly closed or latched. The appliance uses a door switch to confirm the door is secure before allowing water to enter the tub. When that confirmation signal is missing, the PA code appears and the cycle will not proceed. Closing the door firmly until it clicks is the first step to clearing this error.

The dishwasher is designed to prevent operation when the PA code is active, meaning it will not fill with water or run a cycle until the door is confirmed as closed. This is a safety feature that protects against water leaks from an unlatched door. Do not attempt to bypass or force the appliance to run while this code is present.

If the fix is simply closing the door properly or removing an obstruction, there is no parts cost involved. Replacing a worn door latch assembly typically runs between $20 and $60 for the part, while a door switch is generally in the $15 to $40 range. Adding professional labor, a service call to diagnose and repair a door latch or switch issue commonly falls between $100 and $200 depending on your location and the technician's rates.

Start by opening the door, removing any obstructions along the door gasket or rack edges, and then pushing the door firmly closed until you hear the latch click. If the error returns, inspect the door latch for wear or damage and test the door switch for continuity using a multimeter. A latch or switch that is found to be defective will need to be replaced to resolve the fault permanently.

A reset may temporarily clear the PA code from the display, but the error will return immediately if the underlying cause has not been resolved. If the door latch is worn or the door switch is faulty, the control board will detect the same missing signal as soon as a new cycle is attempted. Fix the physical or electrical cause of the fault first, and the code will not reappear.