Electrolux Dryer Error Code DEMO MODE

DEMO MODE means your Electrolux dryer has been set to a retail demonstration state where it simulates operation without functioning as a normal dryer. The drum may tumble and the display may respond, but the unit will not dry clothes. This is a software setting, not a mechanical failure. It can be cleared quickly using a specific button combination on the control panel.

DEMO MODE itself does not create a safety hazard, but the dryer will not actually dry your laundry while in this state. No heat is produced during the demo cycle. You should exit DEMO MODE before attempting to dry any clothing to ensure the appliance works correctly.

In almost all cases, clearing DEMO MODE costs nothing because it requires only a button press and no parts or service call. If the control board is found to be faulty and unable to hold settings after repeated resets, control board replacement typically runs in the range of $150 to $350 depending on the model and labor costs in your area.

Press and hold the temperature and dryness buttons at the same time for 5 seconds. This resets the dryer to its factory default settings and exits DEMO MODE. Once released, the dryer should be ready for normal operation. If the mode returns after clearing, a control board issue may be present.

Yes, holding the temperature and dryness buttons together for 5 seconds returns the dryer to factory defaults and clears DEMO MODE in the vast majority of cases. A general power reset by unplugging the unit is not sufficient on its own to exit this mode. The specific button combination is required.