Electrolux Microwave Error Code ERROR

The ERROR code on an Electrolux microwave indicates one of several conditions: an incorrect or out-of-range value was entered for the clock, defrost, or an auto cook function; the humidity sensor failed to detect vapor properly during a sensor cook cycle; or the door was opened or STOP/CLEAR was pressed during the sensor measurement phase. It is a general input and sensor alert rather than a single specific hardware fault. Pressing STOP/CLEAR and re-entering correct values is the recommended first step.

Yes, pressing STOP/CLEAR will clear the ERROR code in most cases. For input errors such as an incorrect clock time or out-of-range defrost amount, clearing and re-entering the correct value is all that is needed. If the error is caused by a faulty humidity sensor, it will likely return whenever sensor cooking is attempted, even after clearing.

If the error is due to a user input mistake, there is no repair cost involved. If the humidity sensor has failed and needs replacement, part costs typically range from $20 to $60 depending on the model, with professional labor adding $75 to $150 on top of that. Sensor replacement is a moderate repair, and some technicians may recommend evaluating the overall condition of the appliance before proceeding.

Press the STOP/CLEAR pad to dismiss the error, then re-enter your settings using values within the accepted range. If you were using a sensor cook function, restart the cycle and avoid opening the door or pressing STOP/CLEAR during the initial measurement phase. If the error continues to appear during sensor cooking even with proper use, the humidity sensor may need to be inspected or replaced.

In most cases, the ERROR code is not a safety issue. It primarily indicates an input mistake or a disrupted sensor reading cycle. If the error is appearing repeatedly during sensor cooking without any user interruption, it may indicate a sensor problem, but the microwave can still be used safely on manual cook settings while you troubleshoot.