Error code reference

GE Oven Error Code F

Function error code indicated by 'F' followed by a number or letter flashing in the display with an audible signal, indicating an oven control malfunction.

SourceGE Built-In Oven - Use & Care Manual: Self-Cleaning with Trivection™ (JT930, JT980)p. 9, 42-43

Diagnostic procedure

The full F procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
Press the CLEAR/OFF pad. Allow the oven to cool for one hour. Put the oven back into operation. If the function error code repeats, disconnect power to the oven for at least 30 seconds and reconnect power. If it repeats again, call for service.

SourceGE Built-In Oven - Use & Care Manual: Self-Cleaning with Trivection™ (JT930, JT980)p. 9, 42-43

More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock F procedure $9.95

Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.

Where this code is documented

10 manuals in the MyPros+ library document this code for GE oven.

Models covered by the manuals that document this code

More models are covered than are listed here.

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax