GE Washer Error Code 41

Error code 41 on a GE washer indicates a Drive Motor Inverter Fault. The inverter board, which controls motor speed and direction, has detected and reported a fault condition. This prevents the washer from completing cycles that require the motor to spin. Diagnosis should begin with Service Mode test 11, the Spin Test, run to full completion.

You should not continue using the washer while error code 41 is active. The fault indicates the motor control system is not operating correctly, and running the machine could cause further damage to the inverter board or drive motor. It is best to leave the washer unplugged until the fault is diagnosed and repaired.

Unplugging the washer for a few minutes may temporarily clear the error code, but if the underlying fault with the inverter board or drive motor is still present, the code will return during the next cycle. A reset is not a repair, and the fault should be properly diagnosed using Service Mode test 11 before assuming the problem is resolved.

Some causes of error code 41, such as a loose wiring harness connector or a one-time overload from a heavy load, can be addressed without replacing parts. However, if the inverter board or drive motor has failed, those repairs involve high-voltage components and are best handled by a qualified technician. Running the diagnostic spin test first will help narrow down whether a simple fix is possible.

Repair costs vary depending on the root cause. Replacing a drive motor inverter board typically runs between $150 and $350 in parts and labor, while a drive motor replacement can range from $200 to $450 or more depending on the model and labor rates in your area. If the issue is only a loose harness connection, the cost may be limited to a service call fee.