GE Washer Error Code 50

Error code 50 on a GE washer indicates an inverter fault, meaning the inverter board has detected and reported a problem. The inverter board controls the drive motor speed and torque, so this fault typically causes the washer to stop during or before the spin cycle. Diagnosing this code involves running Service Mode spin test 14 and checking all wiring connections at the inverter board.

No, you should not continue running the washer when error code 50 is active. The fault indicates a problem with the motor control electronics, and operating the machine in this condition could worsen the damage or create an electrical hazard. Allow the washer to cool down, then have the fault diagnosed before running another cycle.

Repair costs depend on what component is at fault. If only a wiring harness connection needs to be reseated or cleaned, the cost may be limited to a service call fee, typically in the range of $75 to $150. If the inverter board requires replacement, parts and labor combined can range from $200 to $450 or more depending on the specific model and your location.

Some causes of error code 50, such as a loose or corroded harness connector, can be addressed by a knowledgeable DIYer who is comfortable working inside the washer cabinet. However, accessing the inverter board requires disassembly and involves components connected to line voltage, so care is essential. If the inverter board or motor needs replacement, a technician familiar with GE washer service procedures is recommended.

A power reset may temporarily clear the code if the fault was caused by a transient event, but the code will return if an underlying problem exists. Unplugging the washer for a few minutes and restarting is a reasonable first step, but if error 50 comes back, the root cause must be diagnosed and repaired. Repeatedly resetting without addressing the fault can allow further damage to develop.