GE Washer Error Code 60

Error code 60 on a GE washer indicates a problem with the door lock assembly or its associated wiring. The control board cannot confirm that the door is properly locked, so the machine stops operation as a safety measure. The issue may be a loose wiring connection, corroded terminals, or a failed component inside the lock assembly itself.

No, you should not attempt to run a wash cycle while error code 60 is active. The error exists because the control board cannot confirm the door is securely locked, and the washer is designed to prevent operation under that condition. Running a washer with an unconfirmed door lock state risks water leakage or the door opening during a cycle.

A reset may temporarily clear the code, but if the underlying wiring or lock assembly problem still exists, the error will return as soon as the washer attempts to lock the door again. A reset is useful for confirming whether the fault is intermittent, but it is not a fix. The root cause in the wiring or door lock assembly must be identified and corrected to permanently resolve the error.

In many cases, yes. Start by unplugging the washer and inspecting the wiring harness connections at the door lock and at the main control board, as a loose connector is the most common cause. If reconnecting or cleaning corroded terminals resolves the signal issue, no parts are needed. If the lock assembly itself has failed electrically, replacing it is a straightforward repair that many technicians and experienced DIYers can complete with basic tools and a multimeter.

If only a wiring connection needs to be reseated or cleaned, the repair can cost nothing beyond your time. A replacement door lock assembly typically ranges from $30 to $80 for the part, depending on the specific model. If professional labor is required, expect total repair costs in the range of $100 to $200 depending on your location and service provider.