GE Washer Error Code 62

Error code 62 on a GE washer means the machine detected that full inverter power was being requested while the door remained unlocked for more than 5 seconds. This is a safety interlock fault that prevents the motor from running at full speed without a confirmed door lock. The issue typically involves the door lock assembly, its wiring, or the main control board.

No, you should not continue using the washer while error code 62 is active. This code indicates that the door lock safety interlock is not functioning correctly, which means the machine could potentially operate without a secured door. Stop using the appliance and diagnose the fault before running any wash cycles.

Repair costs depend on which component has failed. A replacement door lock assembly typically runs in the range of $20 to $75 for the part alone. If the main control board requires replacement, parts can range from $100 to $300 or more depending on the model. Adding professional labor, total repair costs can range from $150 to $450 or higher for more complex faults.

Some causes of error code 62 are DIY-friendly, such as checking for a misaligned door latch or inspecting the wiring harness for loose connectors. If the door lock assembly itself has failed, replacing it is a moderate repair that many experienced DIYers can handle. However, if the control board or inverter circuit is the source of the fault, professional diagnosis and repair is recommended.

A reset may temporarily clear the code display, but it will not fix the underlying problem. If the door lock assembly, wiring, or control board has a genuine fault, the error will return as soon as the washer attempts to run again. A proper component-level diagnosis following the Fault Code 2 troubleshooting steps is necessary to resolve the issue permanently.