GE Washer Error Code DA

The DA code on a GE washer indicates an IMC (Inverter Machine Control) fault. The IMC is the board that controls the drive motor and manages spin and wash cycle operations. When this board detects an internal fault or a communication problem, it stops the machine and displays DA. The fix can range from a simple reset to replacing the IMC board depending on the underlying cause.

Start by unplugging the washer for 30 seconds and then running a Drain and Spin cycle. If the code clears, monitor the machine for recurrence. If the code returns, inspect the wiring harness and connectors at the IMC board and drive motor for looseness, corrosion, or damage. If wiring checks out, the IMC board or drive motor may need to be replaced.

If the reset resolves the issue, there is no parts cost involved. If the IMC board needs to be replaced, parts and labor can typically range from around $150 to $400 or more depending on the specific model and local labor rates. Drive motor replacement, if that is the root cause, can fall in a similar or higher range. Getting a diagnosis from a qualified technician before ordering parts is advisable.

Unplugging the washer for 30 seconds performs a hard reset of the IMC and can clear the DA code if the fault was caused by a temporary electrical event. After plugging the unit back in, run a Drain and Spin cycle to see if the code returns. If it does, the underlying issue is likely a hardware fault that requires further diagnosis.

It is not recommended to continue using the washer while the DA code is active. The IMC controls the drive motor, and operating the machine with a confirmed IMC fault could cause additional damage to the motor or associated components. After a reset, if the code clears and the washer runs normally, it is generally safe to use, but watch for the code returning.