GE Washer Error Code F/22

F/22 indicates a communication error between the touchpad/LED assembly (the button panel) and the CCU (the main control board). The two components are unable to send or receive data from each other. This can cause the washer to ignore inputs or stop operating. The issue is most often a loose or corroded wiring connection between the two components.

A reset, performed by unplugging the washer for a few minutes and powering it back on, may temporarily clear the code if the communication fault was caused by a one-time glitch. However, if the underlying cause is a loose connector, corroded pins, or a failed component, the error will return. A reset should be used as a first step, not a final solution.

If the fix is simply reseating a loose harness connector, there is no parts cost, only your time. If the touchpad/LED assembly needs replacement, parts typically range from $50 to $150 depending on the model. A CCU replacement is generally more expensive, often in the $100 to $300 range for the part alone, plus labor if you use a technician.

In many cases, yes. Start by unplugging the washer and checking the wiring harness connections between the touchpad/LED assembly and the CCU for loose plugs or corroded pins. Reseating the connectors often resolves the error. If the wiring is intact and the touchpad does not respond to any button selections, the panel or the CCU may need to be replaced, which is a more advanced repair.

It is not recommended to continue running the washer while the F/22 error is active. The communication failure between the control board and the touchpad means the washer may not respond correctly to commands, which could result in improper cycle operation. Diagnose and resolve the fault before resuming normal use.