Skip to main content
Error code reference
Ingersoll Rand Furnace Error Code E17
Blower motor no communication response - IFC does not see a return signal from the blower motor.
SourceIngersoll Rand S9V2 Furnace - Service Facts: Gas-Fired Condensingp. 55, 59, 82
Diagnostic procedure
The full E17 procedure
Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.
MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
Disconnect power, verify 4-pin motor communication connector is installed and fully seated on IFC, verify 9-pin connector at blower vestibule panel is fully seated, verify 4-pin connector at blower is fully seated.
SourceIngersoll Rand S9V2 Furnace - Service Facts: Gas-Fired Condensingp. 55, 59, 82
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock E17 procedure $9.95
Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.
Where this code is documented
1 manual in the MyPros+ library documents this code for Ingersoll Rand furnace.
Models covered by the manuals that document this code
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax