Jenn-Air Range Error Code SAb

SAb indicates that the oven is in Sabbath Mode, a special operating mode designed for religious observances. In this mode, the oven holds a set temperature continuously and does not respond to standard control pad interactions. The display first flashes SAb during activation, then shows it continuously. This is not a fault code and does not indicate any malfunction.

Yes, the oven is safe to use while in Sabbath Mode. The mode is a designed feature, not an error condition, and the oven continues to operate normally at its set temperature. The main difference is that standard control responses are suppressed while the mode is active, so you will need to cancel the mode before using the oven in its normal way.

There is no repair cost associated with the SAb code because it is not a malfunction. Canceling Sabbath Mode requires only pressing and holding the Setup pad for five seconds at no cost. If the control panel is not responding to the Setup pad at all, that could indicate a separate control board or keypad issue, which would typically involve diagnostic fees and part costs ranging from around 150 to 400 dollars or more depending on the specific repair needed.

To cancel Sabbath Mode, press and hold the Setup pad on the control panel for five seconds. The oven should return to its normal standby state and the SAb display will clear. If the display does not clear after holding the Setup pad, confirm you are pressing the correct pad and holding it for the full five seconds.

A standard power reset by unplugging the range or tripping the circuit breaker may not reliably clear Sabbath Mode, as the setting can persist through power cycles depending on the control board programming. The correct method to cancel the mode is to press and hold the Setup pad for five seconds while the range is powered on.