Maytag Dishwasher Error Code Clean + Keypad 7 LED

The Clean + Keypad 7 LED combination indicates a memory or software check failure detected immediately when the control board powers up. The board runs an internal self-diagnostic at startup and reports this code when it cannot verify the integrity of its own memory or firmware. This is an internal board fault, not a wiring or sensor issue. Control board replacement is the required repair.

Cutting power to the dishwasher may temporarily clear the error display, but the code will return the next time the control board powers up if the underlying memory fault is still present. Because the check runs automatically at startup, the fault cannot be resolved through a reset alone. Board replacement is the only lasting fix.

The cost depends primarily on the price of the replacement control board and whether you hire a technician. Control boards for Maytag dishwashers typically range from $100 to $250 in parts alone, depending on the model. If you use a professional repair service, labor charges can add another $80 to $150 to the total. DIY replacement eliminates the labor cost but requires comfort working with appliance electronics.

The repair requires replacing the control board, which is a part-replacement task that some experienced DIYers can perform. You would need to locate the correct replacement board for your specific Maytag model, disconnect power to the dishwasher, and swap the board following safe electrical practices. If you are not comfortable working with appliance electronics, a qualified technician should handle the replacement.

When this error is present, the control board has failed its startup self-check, which means the dishwasher is unlikely to operate a wash cycle normally. Running the appliance in this state is not recommended, as the board may not reliably control water fill, heating, or draining functions. It is best to avoid use until the control board is replaced.