Maytag Washer Error Code ----

The ---- display means the washer is in an inoperative state and cannot run normally. It is not a specific fault code but rather an indicator that a diagnostic code is stored in the control board's memory. You must enter the washer's set-up mode to retrieve the actual fault code and identify which component or system has failed.

No, the washer will not operate while displaying ----, and attempting to force it to run is not recommended. The inoperative state means the control board has determined a condition exists that prevents safe or proper operation. Identify and resolve the underlying fault before attempting to run a wash cycle.

Repair costs depend entirely on the underlying fault code retrieved from set-up mode, which determines which component has actually failed. Minor issues such as a wiring harness connector repair may cost very little, while replacement of a main control board or motor control unit can range from $150 to $400 or more including parts and labor. A diagnostic service call to retrieve and interpret the fault code typically ranges from $75 to $150 before any parts are factored in.

Start by entering the set-up or diagnostic mode on your specific Maytag model to retrieve the underlying stored fault code. The button sequence for entering set-up mode varies by model, so consult the documentation for your unit. Once you have the actual diagnostic code, you can follow the appropriate component-level troubleshooting steps for that specific fault.

A basic power reset, such as unplugging the washer for a minute and restoring power, may temporarily clear the display in some cases, but it will not resolve the underlying fault if a real component failure exists. If the cause of the inoperative state is still present, the ---- display will return. Retrieving and addressing the stored diagnostic code is the correct path to a lasting fix.