Skip to main content
Error code reference
Midea Washer Error Codes
40 error codes documented with diagnostic procedures.
Have your model number? Get codes specific to your unit.
C9The PCB has failed.CLThe door has been opened for over 20 minutes with the Child Lock function activated.E1The unit takes more than 1 hour to fill water (water inlet time over 60 minutes).E10Water level doesn't change within 7 minutes with valves open (no water inlet or water…E11Too much water left in the unit at standby or end of cycle (drain failure detected at end…E12Water level in drum exceeds a certain level for alarm (water fill overflow).E2The unit takes more than 10 minutes to drain (water drainage time over 10 minutes).E20Main PCB cannot get pump signal; water level doesn't change within 3 minutes with pump…E21Water level doesn't change within 3 minutes with pump started (drain timeout).E3The lid is open, or door lock/PCB has failed.E30Door cannot be locked after more than 3 failed attempts.E31Door cannot be unlocked after more than 3 failed attempts.E33Main PCB cannot get water level sensor (water switch) signal.E34Temperature sensor on water heater is open circuit.E35Temperature sensor on water heater is short circuit.E36Water heater doesn't work.E37Drum drying outlet temperature sensor failed; drying function cannot work.E38Drum drying inlet temperature sensor failed; drying function cannot work.E3ADrying heater open circuit; drying function cannot work.E4The unit is out of balance during spin operation.E40EEPROM failed; memory chip of the PCB is broken.E5The washer is not level or the impact switch has failed.E50/E52Inverter PCB overload; unit cannot work.E50/E53Inverter module temperature failure; unit cannot work.E50/E55Motor speed signal lost; unit will stop operation.E50/E56Motor temperature over-protection; unit will stop operation.E50/E57Inverter module temperature failure; unit will stop operation.E50/E58Inverter module failure; unit will stop operation.E50/E5AConnection failure between inverter module and main control PCB; unit will stop operation.E50/E5BInverter module failure; unit will stop operation.E50/E5COver voltage on inverter module; unit will stop operation.E50/E5DLow voltage on inverter module; unit will stop operation.E50/E5EInverter module failure; unit will stop operation.E64Signal between main PCB and inverter PCB is abnormal; unit will stop operation.E70Button blocked/stuckE80Main PCB cannot get signal from display PCB; unit cannot work.E81Main PCB cannot get signal from display PCB; unit cannot work.F2The PCB has failed.F8Water leveling sensor has failed.FdDoor lock has failed.
Get the full diagnostic procedure for any code
Step-by-step tests, expected values, wiring diagram references, and verified part numbers.
Get Started $9.95 3-day pass$29/month for unlimited access to all brands and Max AI diagnostics.
More Midea error codes
Common questions
How do I find the error code on my Midea Washer?
Most Midea washers show the code directly on the control panel display. If your model has no display, it can be read by entering diagnostic mode with the key sequence for your model. The full procedures include model-specific instructions for reading codes.
Are these codes specific to my model?
The codes here apply broadly to Midea washers. Meanings and diagnostic steps can vary by model and production year, so enter your model number for model-specific information and procedures.
What do I do if my code is not listed?
Some codes are model-specific or only appear in diagnostic mode. Enter your model number to get codes specific to your unit, or contact us. We update the database continuously from manufacturer service documentation.
How much does it cost to access the full diagnostic procedures?
A 3-day pass is $9.95 one-time and gives full access to all brands, codes, and procedures. Monthly access is $29/month with unlimited access to everything including Max AI diagnostics.