Samsung Dishwasher Error Code 6E2

The 6E2 error code means the dishwasher has detected a button that appears to have been continuously pressed for 30 seconds or more. The control system interprets this as a stuck button fault rather than an intentional input. The issue can originate from a physically stuck button, a misaligned control panel pressing against a button, or a failure in the Main or Sub PCB. The dishwasher will not operate normally until the fault is resolved and the code is cleared.

It is not recommended to continue running the dishwasher while the 6E2 error is active. The code indicates the control system has detected an abnormal input condition, and the dishwasher may not respond correctly to your commands during a cycle. Using the appliance in this state risks unexpected behavior, and if water intrusion is involved, continued use could cause additional damage to the electronic components.

Repair costs vary depending on the root cause. If the fix is as simple as realigning the control panel, there may be no parts cost at all, only your time or a basic service call fee. Replacing a touchpad membrane or control panel assembly typically falls in the range of $50 to $150 for parts, plus labor if applicable. A Main or Sub PCB replacement is more expensive, with parts commonly ranging from $100 to $300 or more depending on the model, in addition to any labor charges.

In some cases, yes. Start by inspecting the control panel for any visible misalignment, warping, or buttons that appear depressed or sticky. If the panel is slightly out of position, reseating it may clear the fault. Cleaning around the buttons to remove debris or residue is also worth trying. If those steps do not resolve the issue, the repair likely requires replacing the touchpad membrane, control panel assembly, or a PCB, which is more involved and may benefit from professional service.

A reset may temporarily clear the 6E2 code, but it will return if the underlying cause is not addressed. You can attempt a reset by turning off the dishwasher at the circuit breaker for a few minutes and then restoring power. If the stuck button condition still exists physically or electronically, the code will reappear once the dishwasher detects the continuous input signal again.