Samsung Dishwasher Error Code AE2

The AE2 code indicates a communication failure between the main control board (main PBA) and the inverter control board (inverter PBA). The main board sent signals to the inverter board and received no response for 5 seconds, and this failure repeated three times before the code was displayed. The dishwasher shuts down the inverter relay for 1 minute between each attempt as a protective measure.

No, the dishwasher will not complete a wash cycle while the AE2 error is active because the inverter relay is disabled as part of the fault response. Continuing to attempt cycles without resolving the communication fault could place additional stress on the control boards. The appliance should be repaired before returning to regular use.

Repair costs vary depending on the root cause. If only the wiring harness or connector needs attention, costs are typically limited to a service call fee in the range of $75 to $150. If the inverter PBA or main PBA requires replacement, parts alone can range from $100 to $300 or more, with total repair costs including labor potentially reaching $200 to $450 depending on your location and service provider.

A knowledgeable DIYer can start by checking whether the wiring harness between the main PBA and inverter PBA is fully connected and free of visible damage or corrosion. If the connectors look clean and secure, diagnosing or replacing the circuit boards involved typically requires familiarity with appliance electronics and is better handled by a technician.

A reset may temporarily clear the displayed error, but the code will return if the underlying communication problem has not been resolved. Because the AE2 code only appears after the failure repeats three times, a reset that clears the display does not mean the fault is fixed. The wiring and boards must be inspected to prevent the error from recurring.