Samsung Dishwasher Error Code Button error

A button error on a Samsung dishwasher means the control board has detected a fault with one or more of the control panel buttons. This can be caused by a stuck button, moisture under the panel, a damaged membrane keypad, or a control board issue. The error is the dishwasher's way of signaling that it cannot process button inputs correctly and will not operate normally until the fault is resolved.

Start by powering the dishwasher off completely and then turning it back on to see if the error clears. If the error returns, inspect each button on the control panel for any that feel stuck or are not releasing properly, and carefully clean around the panel surface to remove any moisture or debris. If the error continues after these steps, the membrane keypad or control board may need professional diagnosis and replacement.

If the issue is a stuck button or debris under the panel, there may be no parts cost involved at all. A replacement membrane keypad or control panel assembly typically costs in the range of $50 to $150 for parts, depending on the model. A main control board replacement is more expensive, generally ranging from $100 to $250 or more for the part alone, with additional labor costs if a technician performs the repair.

Turning the dishwasher off and restarting it is the recommended first step and will clear the error if the cause was a temporary electrical glitch. However, if a button is physically stuck, the membrane is damaged, or a component has failed, the error will return after the reset. A persistent button error after restarting requires a physical inspection of the control panel.

When a button error is active, the dishwasher will typically not operate normally and may not respond to input commands. It is not recommended to attempt to force the appliance through a cycle when this error is displayed. Addressing the fault first ensures the control system is reading inputs correctly and that the dishwasher will run as intended.