Samsung Dishwasher Error Code Drain error

The drain error means the dishwasher detected that water could not be removed from the tub properly during or after a cycle. The control board monitors the drain process and stops operation when water remains beyond the expected time. The issue can be mechanical, such as a clogged hose or filter, or it can indicate a problem with the drain pump motor itself.

No, you should not continue running the dishwasher while the drain error is active. The error indicates water cannot leave the tub, and forcing additional cycles could lead to overflow or internal water damage. Close the water supply valve as a precaution until the problem is identified and resolved.

If the fix is as simple as clearing a kinked hose or cleaning the filter, there is no parts cost involved. If the drain pump motor needs replacement, parts and labor costs typically range from $150 to $350 depending on the service provider and part availability. Getting a diagnostic visit from a technician before committing to a repair is a good way to confirm the cause and get an accurate estimate.

Start by checking the drain hose for kinks, folds, or clogs along its entire length. Next, remove and clean the filter basket at the bottom of the tub, and make sure the sink drain or garbage disposal connection is clear and unobstructed. If these steps do not resolve the error, Samsung recommends closing the water supply valve and contacting an authorized service center, as the drain pump may need professional diagnosis or replacement.

Resetting the dishwasher may clear the error code temporarily, but it will not fix the underlying cause. If the drain path is still blocked or the pump is faulty, the error will return as soon as the next cycle attempts to drain. Address the physical cause first, then reset the appliance to confirm the issue is resolved.