mypros+
Error code reference

Samsung Refrigerator Error Code 35

Freezer low register error.

Avg. service call
$285
National average. Trip fee plus diagnostic plus labor. Before parts.
MyPros+ 3-day pass
$9.95
Same diagnostic steps, on your phone. Start now.
You keep in your pocket
~$275
Even before you buy the part.
Skip the service call. Fix it yourself.
Full procedure unlocks instantly.
Get Started

What the 35 error code actually means

Your Samsung refrigerator is showing error 35 because the freezer temperature sensor is sending a reading that is too low for the control board to accept as valid. This usually means the sensor itself has failed or there is a wiring problem between the sensor and the control board. Your freezer may still be running, but the refrigerator cannot properly manage temperatures until the issue is resolved.

Diagnostic procedure

The full 35 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
Confirm the fault
Power cycle the unit: switch off the breaker for 60 seconds, then restore power. If the code returns, the fault is persistent and the procedure below isolates the cause.
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock 35 procedure $9.95

Or subscribe: $29/month for unlimited access to all codes plus Max AI diagnostics.

Most common causes of 35

Ranked by how often they cause this code
  1. 1Failed freezer thermistor
  2. 2Wiring harness short or break
  3. 3Damaged or corroded connector
  4. 4Ice accumulation around the sensor
  5. 5Faulty main control board

Most DIYers save hundreds by diagnosing before ordering parts.

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass

Questions people ask about 35

What does 35 mean on a Samsung refrigerator?
Error code 35 on a Samsung refrigerator indicates a freezer low register error, meaning the control board is receiving a temperature sensor signal from the freezer compartment that falls below the acceptable range. This points to a problem with the freezer thermistor, its wiring, or the connector linking it to the control board. The freezer may continue running, but temperature regulation will be compromised until the fault is corrected.
Will resetting my Samsung refrigerator clear error code 35?
Resetting the refrigerator by unplugging it for a few minutes may temporarily clear the error display, but the code will return if the underlying fault in the thermistor circuit has not been repaired. A reset does not fix a failed sensor, damaged wiring, or a faulty connector. Use the reset only as part of diagnostics, not as a permanent solution.
How much does it cost to repair error code 35 on a Samsung refrigerator?
If only the freezer thermistor needs replacement, parts typically cost in the range of $15 to $50, making it one of the more affordable refrigerator repairs. If a service technician is needed for diagnosis and labor, total costs commonly fall between $100 and $250 depending on your location and the shop rate. Replacing the main control board, if required, will increase the cost significantly, often ranging from $200 to $400 or more with labor.
Can I fix error code 35 on my Samsung refrigerator myself?
A knowledgeable DIYer can handle several steps of this repair, including inspecting the wiring harness, checking the thermistor connector for corrosion, and testing the thermistor resistance with a multimeter. If the thermistor tests out of range, replacing it is a relatively straightforward repair. However, if the issue involves the main control board, professional service is recommended.
Is error code 35 on a Samsung refrigerator a safety concern?
Error code 35 is primarily a performance and reliability issue rather than an immediate safety hazard. However, because the control board cannot accurately regulate freezer temperatures without a valid sensor signal, food stored in the freezer may be at risk of improper temperatures over time. It is best to address the error promptly and monitor freezer temperatures with a standalone thermometer in the meantime.

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass