Samsung Refrigerator Error Code Fd

Fd indicates that the Samsung refrigerator has been placed into a test mode that runs a manual defrost cycle simultaneously in both the fresh food and freezer compartments. This is a diagnostic indicator, not a fault code. It means the unit is intentionally defrosting both sections at the same time as part of a test routine. Pressing any key on the control panel will cancel this mode and restore normal operation.

The Fd code presents no safety hazard. It simply means the defrost heaters in both compartments are running as part of a controlled test sequence. The refrigerator's built-in defrost termination components will prevent overheating, and the condition can be immediately cancelled by pressing any control panel key.

In the vast majority of cases, the Fd code costs nothing to resolve because it is a test mode indicator that clears by pressing any button. If the code is appearing repeatedly due to a faulty control panel membrane or display board, replacement part and labor costs can range from around $100 to $300 or more depending on the specific model and service provider.

No repair is needed for the Fd code. Press any button on the refrigerator's control panel to exit test mode and return the unit to its normal operating state. If the code reappears on its own without anyone pressing a button sequence to trigger it, inspect the control panel for stuck or damaged keys that may be inadvertently re-entering diagnostics.

Yes, pressing any key on the control panel is sufficient to cancel the test mode and clear the Fd display, returning the refrigerator to normal operation. A full power reset by unplugging the unit will also exit the test mode. No additional reset procedure is required since Fd is not a stored fault code.