mypros+
Error code reference

Samsung Refrigerator Error Code Ice Room Sensor Error

Ice Room temperature sensor error due to separation of sensor housing, contact error, disconnection, or short circuit; or detected temperature…

Avg. service call
$285
National average. Trip fee plus diagnostic plus labor. Before parts.
MyPros+ 3-day pass
$9.95
Same diagnostic steps, on your phone. Start now.
You keep in your pocket
~$275
Even before you buy the part.
Skip the service call. Fix it yourself.
Full procedure unlocks instantly.
Get Started

What the Ice Room Sensor Error error code actually means

This error means your Samsung refrigerator's ice compartment temperature sensor is not working correctly. The sensor may have come loose, lost its connection, or failed entirely, so the refrigerator cannot properly monitor the temperature in the ice maker area. Until the issue is fixed, ice production and ice compartment cooling may be unreliable.

Diagnostic procedure

The full Ice Room Sensor Error procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
Check voltage of MAIN PCB CN78-"10" to CN78-"1"; shall be between 4.5V~1.0V.
More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock Ice Room Sensor Error procedure $9.95

Or subscribe: $29/month for unlimited access to all codes plus Max AI diagnostics.

Most common causes of Ice Room Sensor Error

Ranked by how often they cause this code
  1. 1Sensor connector contact error
  2. 2Sensor housing separation
  3. 3Wiring harness disconnection or damage
  4. 4Failed or shorted ice room sensor
  5. 5Main PCB fault

Most DIYers save hundreds by diagnosing before ordering parts.

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass

Questions people ask about Ice Room Sensor Error

What does Ice Room Sensor Error mean on a Samsung refrigerator?
This error means the temperature sensor inside the ice room compartment has a fault. The refrigerator detected either a temperature reading outside the valid range (above +149°F or below -58°F) or a signal problem caused by a loose connector, disconnected wire, separated sensor housing, or a short circuit in the sensor circuit. The main PCB uses this sensor to control cooling and ice production in the ice compartment, so the error must be resolved for normal operation.
Is it safe to keep using my refrigerator when this error appears?
The refrigerator's main food compartment may continue cooling normally, but the ice maker section can behave unpredictably when this error is active. Ice production may stop or operate incorrectly. It is best to address the error promptly, but the unit is generally not a safety hazard in the short term as long as food temperatures in the main compartment remain acceptable.
Will resetting my Samsung refrigerator clear the Ice Room Sensor Error?
A reset may temporarily clear the error code, but it will return if the underlying problem is not corrected. The error is generated by an actual out-of-range voltage or signal condition at the sensor circuit, so resetting the board without fixing the sensor, connector, or wiring will not resolve the fault. Always diagnose and repair the root cause before relying on a reset.
Can I fix the Ice Room Sensor Error myself?
Some causes are DIY-friendly. You can inspect and reseat the sensor connector at the main PCB (checking CN78 pins 10 and 1 for voltage between 1.0V and 4.5V), re-secure a sensor that has separated from its housing, and visually inspect the wiring harness for obvious damage. If the sensor itself has failed or the main PCB is faulty, part replacement is required and may be better handled by a technician if you are not comfortable with appliance wiring.
How much does it cost to repair the Ice Room Sensor Error?
If only a connector needs reseating, there may be no parts cost at all. A replacement ice room temperature sensor typically costs between $10 and $40 for the part. If the main PCB requires replacement, parts alone can range from $100 to $300 or more, with additional labor costs if a technician performs the repair.

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass