Whirlpool Washer, Dryer Error Code Single STATUS LED flashing

A single flashing STATUS LED on a Whirlpool washer/dryer indicates that the dryer door was opened during an active cycle. The flashing LED corresponds to whichever cycle phase was running at the time: Drying, Cool Down, or Finish Guard. The unit has paused and is waiting for you to close the door and press START. This is a status notification, not a fault code.

Closing the door and pressing START is the intended way to clear this status and resume the cycle. A full reset is not necessary for this condition. If the LED continues to flash even after the door is securely closed, there may be an underlying issue with the door latch or door switch that should be inspected.

In most cases, there is no cost at all since the condition is resolved by simply closing the door and pressing START. If the root cause turns out to be a faulty door latch or door switch, replacement parts for those components typically range from $15 to $60 depending on the part, with additional labor costs if a technician is needed.

Close the dryer door firmly until it latches and press the START button within five minutes of when the door was opened. The cycle should resume from where it left off. If you miss the five-minute window, you may need to start a new drying cycle.

No, the flashing LED is a built-in safety and usability feature, not an indicator of a dangerous condition. The machine pauses operation when the door is opened to prevent the drum and heater from running with an open door. The five-minute wait window allows you to safely retrieve items before the cycle is cancelled.