Whirlpool Washer Error Code FCE8

FCE8 indicates that the washer's Wi-Fi module is not responding or is not connected to the UIC Control Board. The code is triggered when the control board cannot establish communication with the Wi-Fi module. This affects smart connectivity features but does not prevent the washer from running wash cycles normally.

A power cycle, achieved by unplugging the washer for one to two minutes, may temporarily clear FCE8 if the cause is a software glitch in the Wi-Fi module. However, if the fault is due to a loose connection, damaged harness, or failed component, the code will return after the reset. A permanent fix requires addressing the underlying hardware issue.

If the fix is simply reseating a loose harness connector, there is no parts cost involved. A replacement Wi-Fi module typically costs in the range of $30 to $100 for the part, depending on the specific model. If the UIC Control Board is the faulty component, board replacement costs generally range from $100 to $250 or more for parts alone, with additional labor costs if a technician is performing the repair.

Start by unplugging the washer and inspecting the wiring harness that connects the Wi-Fi module to the UIC Control Board. Check that both connectors are fully seated and look for any damaged or corroded wires. If the harness is intact, the Wi-Fi module itself may need to be replaced. If the error persists after module replacement, the UIC Control Board could be the source of the fault.

No, FCE8 is not a safety-related error. It only affects the washer's Wi-Fi and smart connectivity functions. The washer should continue to operate normally for all standard wash and spin cycles while this code is active.