Whirlpool Washer Error Code NO WATER DETECTED

This error means the washer's pressure switch did not detect a sufficient water level within 6 minutes of the fill cycle starting. The machine monitors water level using a pressure switch connected to the tub via an air hose. When water fails to reach the correct level in time, the control board halts the cycle and displays this code. The issue could be with the water supply, the inlet valve, or the pressure sensing system itself.

A reset may clear the code temporarily, but if the underlying problem is not resolved, the error will return during the next fill cycle. To reset the washer, unplug it for one minute and then restore power. Address the root cause, such as the water supply or a faulty inlet valve, before running another cycle.

Repair costs vary depending on the root cause. If the fix is simply opening a closed supply valve or cleaning inlet screens, there is no parts cost. Replacing a water inlet valve typically runs in the range of $30 to $100 for the part, while a pressure switch replacement is generally $15 to $60. Adding professional labor will bring total repair costs to approximately $100 to $250 depending on your location and the technician's rates.

Start by confirming that both hot and cold water supply valves behind the washer are fully open and that the inlet hoses are not kinked. Next, check the inlet valve screens for sediment buildup and clean them if blocked. If water is confirmed inside the tub, inspect the pressure switch air hose for disconnections or cracks and test the pressure switch and inlet valve for proper operation.

The washer will not complete a wash cycle in this fault state, so there is no risk of running a wash without water. However, you should not attempt to bypass the error and force the machine to run until the cause is diagnosed. Continuing to attempt cycles with a faulty inlet valve or wiring issue could stress other components over time.