mypros+
Model reference

Whirlpool WFW8200TW01

Washer

4 documents17 error codes3 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10138094 - Rev A16 pg
    Covers this model

Bulletin

  • Service Pointer - 81787722 pg
    Covers this model

Quick Reference

  • Quick Reference Manual6 pg
    Covers this model

Other

  • Service Pointer - 8178722 (Excessive Shaking)_81787221 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WFW8200TW01.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (17)

CodeMeaning
DISPENSER SYSTEM ERRORThe dispenser motor cannot be driven to its proper position.DOOR LOCK ERRORAfter 6 failed attempts to lock the door.DOOR SWITCH ERRORThe door has not been opened for 3 consecutive cycles or the door switch is…DOOR UNLOCK ERRORThe door unlock has failed 6 times.DRIVE MOTOR TACHOMETER ERRORThe control is unable to properly detect motor speed; the machine shuts downEEPROM ERRORA communication error between the Central Control Unit (CCU) and the EEPROM…LOAD INSIDE DRUM DURING CLEAN WASHER CYCLEAt the start of the CLEAN WASHER cycle a load is detected inside the drum…LONG DRAINIf the drain time exceeds 8 minutes the water valves turn off.MAIN RELAYS ERROROne of the main relays is not working properly (relay might be soldered or…MCU FAILUREIf the heat sink gets too hot, the Motor Control Unit (MCU) stops the motor; if…MOTOR CONTROL UNIT ERRORThe Motor Control Unit has internal failure; repeating under or over voltage…NO WATER DETECTEDNo water detected entering machine or pressure switch trip not detected; the…OVERFLOW CONDITIONThe overflow contact on the pressure switch is closed for more than 60 seconds…PUMP DRIVE ERRORThe pump driver fails to activate.PUMP DRIVE SYSTEM ERRORThe connection between the pump and the Central Control Unit (CCU) is lost.SERIAL COMMUNICATION ERRORThe communication between the Central Control Unit (CCU) and the Motor Control…WATER TEMPERATURE SENSOR ERRORThe water temperature sensor (NTC) value is out of range (23°F to 217°F / -5°C…

Service modes (3)

  • Manual Diagnostic Test1
  • Quick Entry Diagnostic Test (bypassing Service History)1
  • Service History Mode & Diagnostic Test1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass