Whirlpool Washer Error Code PUMP DRIVE ERROR

The PUMP DRIVE ERROR means the Central Control Unit attempted to activate its internal pump driver circuit but failed to do so. This prevents the drain pump from operating, which causes the washer to stop mid-cycle. The fault points to a failure in the CCU itself or in the wiring between the CCU and the drain pump.

You should not continue running the washer while this error is active. Because the drain pump cannot activate, water may remain trapped in the drum, and further cycle attempts could stress other components. Unplug the machine until the issue is diagnosed and resolved.

A power reset may temporarily clear the error code from the display, but if the underlying pump driver circuit has failed, the error will return as soon as the washer attempts to drain again. A reset is not a fix for this fault. The root cause in the CCU or wiring must be addressed for the error to be permanently resolved.

A knowledgeable DIYer can start by checking the wiring harness and connectors between the control board and the drain pump for visible damage or looseness. If the wiring is intact, the repair typically requires replacing the CCU board, which involves disconnecting the power supply, removing the old board, and installing a compatible replacement. If you are not comfortable working with appliance control boards, a professional technician is recommended.

If the repair requires a new CCU board, parts alone typically range from $150 to $350 depending on the specific model. Adding professional labor, total repair costs generally fall between $200 and $500. Checking the wiring harness and connectors first costs nothing beyond your time and may resolve the issue without parts.