Model reference

Amana OU-150

Furnace

6 documents26 error codes3 service modes

Available documentation

Tech Sheet

Tech Sheet - 82731888 pg
Covers this model

Quick Reference

Quick Reference Manual4 pg
Covers this model
Quick Start Guide2 pg
Covers this model

Installation Guide

Instruction Sheet2 pg
Covers this model
Instruction Sheet20 pg
Covers this model

Other

Wiring Sheet - W11336171 - Rev A2 pg
Covers this model

MyPros+ Max

Diagnose your Amana OU-150.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Amana Furnace

DOOR LOCKED/CLEANING on my Amana OU-150

M+

Center tap voltage failure; DOOR

From Tech Sheet W14429635, p.47:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure door lock assembly resistance across PTC terminals. Expected: ~200 ohms cold.

3.Inspect strike and latch alignment. A misaligned strike prevents the switch stack from closing.

Part W10810403

Door lock assembly

Error codes (26)

CodeMeaning

DOOR LOCKED/CLEANINGCenter tap voltage failure; DOOR LOCKED/CLEANING and HEATING LEDs flashing…F1 E0EEPROM communication error.F1 E1EEPROM checksum error.F1 E2A/D error(s).F1E7Board thermistor open or shorted.F1E9WIDE File queue full.F2 E0Shorted keypad or key stuck.F2 E1Keytail unplugged.F2E0Keypad disconnected.F2E1Stuck key detected.F2E2Cancel key error.F3 E0Open oven temperature sensor.F3 E1Shorted oven temperature sensor.F3 E2Non-self-clean over temperature condition.F3 E3Self-clean over temperature condition.F3E0Main oven sensor open or shorted.F3E2Warming drawer sensor open or shorted.F5 E0Door and latch switches do not agree.F5 E1Latch motor not operating or latch switch failure.F5 E2Door latch error during clean cycle.F5E0Door and switches do not agree (Clean mode F6E1Over temperature during cook mode.F6E2Over temperature during clean mode.F6E3Over temperature in warming drawer.F9E0Mis-wired house or range.OVEN ONOven knob is not in the OFF position when the range is powered up (LED…

Service modes (3)

Oven temperature adjustment (temperature knob controls)Press and hold CLOCK pad for 5 seconds
Oven temperature adjustment (touch pad controls)Press and hold BAKE pad for 5 seconds
Service Diagnostic Mode / Auto Test["Press CANCEL > CANCEL > START to enter the diagnostic mode.","Press the up arrow, '+' (plus…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana furnace models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass