mypros+
Model reference

Amana RR-9TB/P75043-1M

Microwave

6 documents52 error codes23 service modes

Available documentation

Tech Sheet

  • Failure Code Indications Tech Sheet4 pg
    Covers this model
  • wiring diagram-a.pdf1 pg
    Covers this model
  • FICHE TECHNIQUE - 8304417 - Rev B16 pg
    Covers this model
  • techsheet-w10420006-reva_W1042000656 pg
    Covers this model

Service Manual

  • TECHNICAL MANUAL JennAir® and KitchenAid® Under-Counter Microwave Oven with Drawer55 pg
    Covers this model

Other

  • tech-sheet-W10865055-RevA60 pg
    Covers this model
MyPros+ Max

Diagnose your Amana RR-9TB/P75043-1M.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (52)

CodeMeaning
AFRestricted/low air flow detected that may affect dryer performance.ERRORHumidity sensor (AH sensor) cannot balance the bridge circuit due to…F0 E7Control board recognized line voltage below 90 VAC.F1 E1ACU (Appliance Control Unit) fault.F1 E7ACU voltage input fault.F1E1Indicates a Cycle Control Unit (CCU) problem.F1E3Incorrect controller installed (electric models only); ACU and/or UI part…F1E4MW Relay failure (Relay 4903 on ACU).F1E5ACU parameter file missing; parameter memory invalid.F2 E0Keypad (keyboard) faultF2 E1Keypad (keyboard) faultF2 E2Upper dryer keypad is sensed pressed for 60 seconds (stuck key).F2E1Indicates a stuck button (depressed for over 20 seconds) or UI mismatch; only…F2E2UI cannot read EEPROM software from the User Interface.F2E4UI software errorF2E5UI software errorF3 E2Warming drawer sensor shorted or open circuit.F3E1Exhaust thermistor is open; temperature drops below 18°F (>50k ohms).F3E2Exhaust thermistor has shorted; temperature above 250°F (<500 ohms).F3E3Inlet thermistor is open; temperature drops below 18°F (>245k ohms)F3E4Inlet thermistor is shorted; temperature above 760°F (<20 ohms)F3E5Moisture Sensor 2 Open/Shorted (only Quad Sense models).F3E6Moisture sensor strip is openF3E7Moisture sensor strip has shortedF4 E1Microwave oven convection thermistor fault.F4 E2Microwave oven internal temperature sensor fault.F4 E4Microwave oven humidity sensor fault.F4E1No voltage detected at the heater relayF4E2Heater 2 failure or connector problem (electric models only); no voltage…F4E3Restricted air flow detected that may affect dryer performance.
View all 52 error codes
F4E4Low L2 voltage (less than 50V) detected at the CCU.F5No feature identified for microwaveF5 E0Door and latch switch do not agreeF5 E1Door latch not operatingF5 E6Upper dryer door circuit error.F6 E5No cavity size commandF6E1Communication between the CCU and UI has not been detected (UI to CCU).F6E2Communication between the CCU and UI has not been detected (CCU to UI).F6E3Communication errorF7 E6Lower dryer motor circuit error.F7 E7Upper dryer motor circuit error.F7 E8Lower dryer motor sense errorF7 E9Upper dryer motor sense errorF8E5Exhaust air temperature sensor detection failure.FC E1Model/Serial number not programmed into control.FC E4USB stick failure (USB full, not detected, or not accessible).FC E5Software uploaded from USB stick does not match the model number of the machine.FP E1Coin 1 circuit errorFP E2Coin 2 circuit errorFP E3Card reader communication error.L2Low L2 voltage (less than 50V) detected at the CCU.PFPower failure occurred while the dryer was running.

Service modes (23)

  • AH Sensor Diagnostic Test (Water Load Cooking Test)["Ensure oven has been plugged in at least 2 minutes before testing.","Fill approximately 200 ml…
  • Cavity size programming["Disconnect oven or interrupt power","Wait 10 seconds, reconnect power","Enter diagnostic mode
  • Clear last fault code["Disconnect oven or interrupt power","Wait 10 seconds, reconnect power","Enter diagnostic mode
  • Component ActivationFrom Service Diagnostics Diagnostics Home screen, select 'Component Activation'
  • Customer-Focused Dryness Level Adjustment1. Turn cycle selector knob to an automatic cycle. 2. From the Automatic Cycle Main Screen, press…
  • Diagnostic / Self-Diagnostic Test Mode["Plug in microwave oven or reconnect power.","In idle mode, close the door, turn off hood light…
  • Diagnostic component activation["Enter diagnostic mode (OFF, OFF, START)","Press Bake to activate bake relay","Press Broil once…
  • Diagnostic mode["Press OFF","Press OFF","Press START","If the appliance does not enter diagnostic mode, repeat the…
  • Fahrenheit/Celsius selection["Press OPTIONS then 1"]
  • Help Mode["Enter Setup Mode first.","While in special pricing option step 2.XX (or while dAS displays if…
  • Install Diagnostics["Activate Service Diagnostic Mode first.","Press and release the 2nd button used to activate…
  • Key Activation & Encoder Test["Activate Service Diagnostic Mode first.","Press and release the 1st button used to activate…
  • Model/Serial Number Menu["Enter Help Mode.","While on the S0 screen, press the HEAVY DUTY key.","Use NORMAL key to advance…
  • Quick Diagnostic TestFrom Diagnostics Home screen, select 'Error Diagnostic', then select 'Quick Diagnostic Test'
  • Service Diagnostic Mode["1
  • Service Diagnostics1. Ensure dryer is in standby mode (plugged in with all indicators off). 2. Select any three…
  • Service Test Mode["Activate Service Diagnostic Mode first.","Press and release the 2nd button used to activate…
  • Setup Mode["Stacked PD Models
  • Software Version Display["Activate Service Diagnostic Mode first.","Press and hold the 2nd button used to activate Service…
  • Temperature calibration adjustment["Press OPTIONS then 6","For double oven only, select desired oven (upper or lower)","Press 3 to…
  • UI Component TestFrom Diagnostics Home screen, select 'Component Activation', then select 'UI Component Test'
  • USB Menu["Enter Help Mode.","While on the USB screen, press the HEAVY DUTY key.","Use NORMAL key to advance…
  • User Interface/Control System Test["Activate Service Diagnostic Mode first.","Press and release the 1st button used to activate…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana microwave models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass