mypros+
Model reference

Amana CC-1/P27271-1S

Range

47 error codes12 service modes
MyPros+ Max

Diagnose your Amana CC-1/P27271-1S.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (47)

CodeMeaning
d13Coin 2 errord16Generation 2 debit card reader errord5Coin 1 errord9Low voltage detection errorF01MCC (Central Control Module) communication errorF11Motor Control Module (MCM) failureF1E1ACU errorF1E2Motor control errorF20No water entry detectedF21Excessive drain timeF22Door lock errorF24Water temperature sensor errorF25Tachometer errorF26Door switch errorF27Overflow conditionF28Communication failure between MCC and MCM.F29Motor overheating detected.F2E3Unsupported cycleF30No description availableF31No description availableF33Pump disconnectedF34Load detected in the washer during the washer cleaning cycle.F3E1Water level system errorF3E2Temperature system errorF3E4Mini-bulk sensor failureF4E0Heater is not detectedF5E1Door switch errorF5E2Door lock errorF5E3Door unlock errorF5E4Door not opened between cycles
View all 47 error codes
F6E2Communication error ACU to UIF6E3Communication error UI to ACUF6E5Communication error between ACU and Expansion Board (EB)F70Communication failure between MCC and User Interface (UI).F73User Interface (UI) failureF74User Interface (UI) failureF7E2Motor drive circuit over temperatureF7E8Motor over temperatureF7E9Motor lock rotorF8E0Steam inlet valve errorF8E1No water detected entering washer or water level sensor trip not detectedF8E2Dispenser system errorF8E3Overflow conditionF8E4Flow meter faultF9E1Long drainrLLoad detected during the washer cleaning cycle (saved as F0E1)SudSuds detected

Service modes (12)

  • Diagnostic Mode (Blink Mode)["First access Setup/Configuration Mode.","Press DELICATES & KNITS button for 1 second while one of…
  • Fault/Error Code Display["Enter Service Diagnostic Mode first.","Press and release the 3rd button used to activate Service…
  • Help Mode["PD models
  • Manual Overview Test["Enter Diagnostic Mode (Blink Mode).","Press WHITES button while the display is blinking."]
  • Quick Diagnostic Test["Enter Service Diagnostic Mode first.","Press and release the 2nd button used to activate Service…
  • Quick Drain and Spin["Enter Diagnostic Mode (Blink Mode).","Press COLORS button while the display is blinking."]
  • Quick Overview Test["Enter Diagnostic Mode (Blink Mode).","Press WOOLENS button while the display is blinking."]
  • Service Diagnostic Mode["Ensure washer is in standby mode (plugged in with all indicators off).","Wait 30 seconds after…
  • Setup/Configuration Mode["PD models
  • Software Version Display["Enter Service Diagnostic Mode first.","Press and hold the 2nd button used to activate Service…
  • User Interface Test["Enter Service Diagnostic Mode first.","Press and release the 1st button used to activate Service…
  • Washer Cleaning Program["Enter Diagnostic Mode (Blink Mode).","Press BRIGHT button while the display is blinking."]

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana range models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass