mypros+
Model reference

Caloric DCS211-1L-OA

Dishwasher

26 error codes11 service modes
MyPros+ Max

Diagnose your Caloric DCS211-1L-OA.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (26)

CodeMeaning
:Flashing colon indicates a power failure has occurred.F0E2Over suds condition detectedF0E4High water temperature detected during rinse cycleF0E5Off balance load detected.F1E1Main control fault.F1E2Motor control faultF2Touch panel failure.F2E1Stuck keyF2E3Mismatch of main control and UIF3E1Pressure sensor faultF3E2Inlet water temperature faultF3HHumidity sensor failure.F5E1Lid switch faultF5E2Lid lock faultF5E3Lid unlock faultF5E4Lid not opened between cyclesF6MW relay failure (relay 4903 contact may have welded closed).F7E1Basket speed sensor faultF7E5Shifter faultF7E6Motor faultF7E7Motor unable to reach target RPMF8E1Long fillF8E3Overflow conditionF8E5Hot and cold inlet hoses are reversed.F8E6No fillF9E1Long drain

Service modes (11)

  • Calibration Mode["Activate Service Diagnostic Test Modes (steps 1 and 2).","Toggle cycle selector knob until only…
  • Clean Washer Cycle["Activate Service Diagnostic Test Modes (steps 1 and 2).","Toggle cycle selector knob until…
  • Drain and Spin Cycle["Activate Service Diagnostic Test Modes (steps 1 and 2).","Toggle cycle selector knob until RINSE…
  • Fault Code Display Mode["Activate Service Diagnostic Test Modes (steps 1 and 2).","Toggle cycle selector knob until only…
  • Manual Overview Test Mode["Activate Service Diagnostic Test Modes (steps 1 and 2).","Toggle cycle selector knob until FINAL…
  • Quick Overview Test Mode["Activate Service Diagnostic Test Modes (steps 1 and 2).","Toggle cycle selector knob until only…
  • Self-Diagnostic / Touch Panel and Electronic Control Test["1
  • Service Diagnostic Test Modes (Entry)["Ensure washer is in standby mode (plugged in with all indicators off).","Place cycle selector…
  • Software Version Display Mode["Activate Service Diagnostic Test Modes (steps 1 and 2).","Toggle cycle selector knob until RINSE…
  • Tachometer Verification Mode["Activate Service Diagnostic Test Modes (steps 1 and 2).","Toggle cycle selector knob until…
  • UI Test Mode["Activate Service Diagnostic Test Modes (steps 1 and 2).","Toggle cycle selector knob until RINSE…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Caloric dishwasher models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax