mypros+
Model reference

Fisher & Paykel DS605M

Dishwasher

1 document14 error codes7 service modes

Available documentation

Service Manual

  • Service Manual DishDrawer™ Dishwasher Models: DD605 DS60555 pg
    Covers this model
MyPros+ Max

Diagnose your Fisher & Paykel DS605M.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (14)

CodeMeaning
F1The bottom controller flood sensor detector has been activated for more than…F2The controller has not sensed the motor rotating.F3The water temperature has been sensed as greater than 85°C (185°F).F4No temperature increase has been sensed for about 4 hours while the element is…F5Lid motor current too high during start, indicating lid is jammed up or down.F6Lid motors ran but did not reach stall current.F7No lid motor current detected.F8Earth leakage fault.F9Power supply / controller fault.FFTop tub not responding.U1Machine has failed to prime with water within approximately 3 minutes (fill…U2Restricted lid travelU3Water filled too quickly or tub failed to drain (not displayed to customer…U4Advisory only

Service modes (7)

  • Continuous Cycle Test Mode1. Ensure DishDrawer is in Power Off mode. 2. Press and hold KEYLOCK, then press START/PAUSE for 5…
  • Fast Test Cycle1. Ensure DishDrawer is in Power Off mode. 2. Press and hold KEYLOCK, then press START/PAUSE for 5…
  • Fault Display/Download Mode1. Ensure DishDrawer is in Power Off mode (no display on LCD). 2. Press and hold KEYLOCK, then…
  • Hardware Output Diagnostic Test Mode1. Ensure DishDrawer is in Power Off mode. 2. Press and hold KEYLOCK, then press START/PAUSE for 5…
  • Option Adjustment Mode1
  • Show Off / Showroom Wash Mode1
  • Temperature & Voltage Display Mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Fisher & Paykel dishwasher models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax