Model reference
GE GSD4930Z02WW
Dishwasher
3 documents21 error codes4 service modes
Available documentation
Service Manual
- GE Consumer Service Training Technician Manual GE Built-in Dishwashers Generation-II Value & Smart Models E4 and E5 Controls41 pg
Job Aid
- Dishwasher Front Panel Repair Kit1 pg
Other
- DD04 992 pg
MyPros+ Max
Diagnose your GE GSD4930Z02WW.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (21)
CodeMeaning
C1Slow draining detected; pump-out time exceeds 100 seconds, indicating a partial…C2Drain is blocked; pump-out time exceeds 400 seconds and the dishwasher cannot…C3Drain feedback sensor is not functioning; dishwasher will continue cycle with a…C4Flood condition detected; water level in the dishwasher has exceeded the normal…C5Two consecutive pump-out times of less than 6 seconds detected, indicating no…C6Water temperature did not reach 120°F during the main wash cycle.C7Temperature sensor (thermistor) is open or shorted; heater will not operate…DRY (flashing)Value modelsE4There is too much water in the dishwasher (flood/overfill condition on Smart…E5Not enough water is entering the dishwasher, or the drain pump is temporarily…E6Water temperature in the dishwasher did not reach the proper wash temperature…E7The temperature sensor in the dishwasher is not functioning properly…ERMembrane switch or its connection to the entry/display module is faulty.F0Failed turbidity sensor: LOW SIGNALF1Failed turbidity sensor: HIGH SIGNALF4Failed turbidity sensor: NO SIGNALNORMAL (flashing)Value models F-1 test diagnosticPFElectrical power to the dishwasher has been interrupted but is now back on…POTS/PANS (flashing)Value models F-1 test diagnosticRINSE (flashing)Value modelsWASH (flashing)Value modelsService modes (4)
- Detergent Cup Reset (Smart Models)["Close and latch the door.","Touch the RESET pad three times within 3 seconds.","Display will show…
- F-1 Test Cycle (Smart Models)["Close detergent cup and latch door.","Press NORMAL and DELAY START pads at the same time and hold…
- F-1 Test Cycle (Value Models)["Close detergent cup and latch door.","Press START and DELAY START pads at the same time and hold…
- X10 Speed Test (Value Models)["Press the selected cycle pad (e.g., Normal Wash) for 3 seconds; control will beep twice to…
Full entry steps, exit procedures, and test sequences are available in Max.
Related GE dishwasher models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass